Fixing Kirby handle springs

[seijun]

I have two Kirby's, a 1CR and a DS50, both with non-functioning spring mechanisms in the handles (part that keeps the handle upright). I opened one up and the spring itself looked fine. I can not figure out what the problem is. Has anyone here dealt with this part of a Kirby before? Any idea which part might be broken? If I can figure out where the problem is, maybe I can order a replacement part.

 

[kirbyclassiciii]

Seijun

Pam,


 


Fixing these handle springs is a very difficult thing to do. Here's a tutorial for models 516/D80 from this Kirby service manual... make sure you look specifically at the procedure given for models since the 519.


 


You will need a special spring-winding tool for this (SP123).


 


Currently available replacement parts:


1005 - handle fork pin spring clip


136373 - handle fork spring bushing clip


137067 - handle fork spring


137173 - handle fork spring shaft


137273 - handle fork spring bushing


137373 - handle fork spring screw


137456 - handle fork spring fiber washer


137579 - handle spring yoke


 


Thank you,


 


 


 


Ben

 

[seijun]

Thank you! I am currently trying to convince the vacuum museum to fix it. But these instructions will definitely come in handy! The mechanism is far more complicated than I had realized.

 

[kirbyclassiciii]

Seijun

Pam,


 


You're welcome and good luck!


 


BTW, if the "1CR Classic" you mention is actually a "1CB Classic Omega," then you will need to order part no. 137073 as the handle fork spring.


 


~Ben