human
Well-known member
So I've had this Electrolux Silverado for a couple of months that's missing the entire switch assembly, including its wiring harness. I recently acquired a switch assembly (switch and rocker) from a Super J, so the next step is to figure out how to wire it up. Four questions to begin the process:
1. Does anyone have a wiring diagram they can share a copy of? I guess I could tear down my Super J to see how it's wired, but I'd just as soon have the actual diagram.
2. What gauge wire do I need to use?
3. What size are the flat terminals that go on the ends of the wires?
4. What size screws hold the switch in place?
Thanks in advance. I'm sure I'll have other questions as I get into this project/mess. I don't need another vacuum but I just hate having it sit around in a non-functional state and I do enjoy a good challenge.
1. Does anyone have a wiring diagram they can share a copy of? I guess I could tear down my Super J to see how it's wired, but I'd just as soon have the actual diagram.
2. What gauge wire do I need to use?
3. What size are the flat terminals that go on the ends of the wires?
4. What size screws hold the switch in place?
Thanks in advance. I'm sure I'll have other questions as I get into this project/mess. I don't need another vacuum but I just hate having it sit around in a non-functional state and I do enjoy a good challenge.