Does anyone know anything about what parts numbers were printed on the armatures and fields of Kirby vacuum motor sets through the years, other than those covered in the 1965 edition of the Kirby master service manual?
What I want to find out is which models from the 3C through the 515 would have used the armatures in question - that Kirby says (on page 1-19 in the service manual in question) it would no longer supply replacement armature and field sets which bear the following ID part numbers listed below (but to completely replace with a new one)?
The ID numbers in question are (for which Kirby had no longer supplied replacement armature and field sets for):
Armatures: 10175, 3424, 4579, 4494, 4121
Fields: 10176, 3424, 4579, 4494, 4121
Other then non-current ID numbers from the same service manual:
Armatures: 11320, 10530, 5BA45BD12/A/B (replaced by 12062)
Fields: 11321, 10531, 5BA45BD12/A/B (replaced by 12065)
Again, could anyone please find out for me which Kirby models used these armatures and fields, which have the code numbers listed above, in question?
Thank you,
Ben
What I want to find out is which models from the 3C through the 515 would have used the armatures in question - that Kirby says (on page 1-19 in the service manual in question) it would no longer supply replacement armature and field sets which bear the following ID part numbers listed below (but to completely replace with a new one)?
The ID numbers in question are (for which Kirby had no longer supplied replacement armature and field sets for):
Armatures: 10175, 3424, 4579, 4494, 4121
Fields: 10176, 3424, 4579, 4494, 4121
Other then non-current ID numbers from the same service manual:
Armatures: 11320, 10530, 5BA45BD12/A/B (replaced by 12062)
Fields: 11321, 10531, 5BA45BD12/A/B (replaced by 12065)
Again, could anyone please find out for me which Kirby models used these armatures and fields, which have the code numbers listed above, in question?
Thank you,
Ben