ISO: Kirby Motor Group Parts for 1CB-2HD

[kirbyclassiciii]

If anybody might have any of the following Kirby motor group parts for me, please respond to this. I am specifically looking for the following for both my 1972 Kirby Classic 1CR and my 1974 Kirby Classic Omega 1CB.

My want list:
104569 - field terminal clip for models 1CR to 2HD (pre-9/86), set of 2
107173 - Carbon Brush Cap for models 1CB to 2HD (pre-9/86), set of 2
109367 - field wire insulation tubing for models D50 and D80
109467 - slot insulator for models D50 to 1CR
110973 - brush lead wire, black, for models 1CR to 2HD (pre-9/86) (with old style terminal clip)
111473 - brush lead wire tubing for models 1CR to LII, clear, 1/8" diameter by 3" long
111573 - brush lead wire tubing for models 516 to LII, black, 1/8" diameter by 3" long

All items listed above, I prefer to have two of each.

Thank you,



Ben

 

[lesinutah]

Ben

Those can be had but there going to be used. I'll see what I have.
Les

 

[kirbyclassiciii]

LesinUtah

Les,

The insulation tubings might be a little easier to obtain since they can be purchased locally at a hardware store near you if you know the exact diameter and size. As to the rest, you may be right. I do hope you have at least some of these parts.

~Ben[this post was last edited: 7/13/2020-21:42]

 

[lesinutah]

Ben

I'm not going out on too much of a limb with my next assumption. Electrical tape is very similar to insulation and heat shrink. Albeit no adhesive but more than like same properties.
Les

 

[kirbyclassiciii]

LesinUtah

Les,

I wonder if, with the help of heat shrinking, that it might be possible to wedge a clear plastic tubing (111873) in the slot for the speed switch wires?

~Ben

 

[lesinutah]

Ben

I don't recall which Kirby from d80-heritage did exactly like you mention.
Les

 

[kirbyclassiciii]

LesinUtah

Les,

The picture you are referring to is that of my Dual Sanitronic 80.

~Ben