For those of you that own any or all of these three Kirby cleaners - Dual Sanitronic 50, Dual Sanitronic 80, and Classic 1CR - have any of you tried to add the following parts to enhance the safety of the motor?
The hot sheet:
109467 - fan case slot insulation tubing (D50, D80, 1CR)
111473 - brush wire lead tubing (1CB to L2), used on 110973 terminal
111573 - brush wire insulation tubing (1CB to L2), used on field coil
111773 - foot switch wire insulation tubing (1CB to L2)
111873 - speed switch tubing, black, 3.5" (1CB to 3CB)
111973 - speed switch tubing, clear, 6.5" (1CB to 3CB)
Reason I ask: part no. 111973 shows up in the 1974 updated version of the Classic 1CR parts diagram, marked as item 57. To compare, I am also uploading the equivalent pages of the Classic Omega 1CB service manual about how to do this.
~Ben










The hot sheet:
109467 - fan case slot insulation tubing (D50, D80, 1CR)
111473 - brush wire lead tubing (1CB to L2), used on 110973 terminal
111573 - brush wire insulation tubing (1CB to L2), used on field coil
111773 - foot switch wire insulation tubing (1CB to L2)
111873 - speed switch tubing, black, 3.5" (1CB to 3CB)
111973 - speed switch tubing, clear, 6.5" (1CB to 3CB)
Reason I ask: part no. 111973 shows up in the 1974 updated version of the Classic 1CR parts diagram, marked as item 57. To compare, I am also uploading the equivalent pages of the Classic Omega 1CB service manual about how to do this.
~Ben









