lux14
Well-known member
Question for you experts:
I have a PN 2 power nozzle that cuts out intermittently. I can run it for a few minutes but then it cuts out. I don't think the motor is bad. The power nozzle had not been turned on for quite some time and may not be used to running? I am wondering if something needs lubing but have no idea where to apply or what to apply from a lube perspective. The motor does not get too hot or anything like that. The motor sounds fine when it is running. I was thinking about taking the motor apart and cleaning any dust that might be hindering something. The brush roll is clear of any hair so that is not the issue.
Does anyone have any recomondations for trouble shooting?
Thanks much!
I have a PN 2 power nozzle that cuts out intermittently. I can run it for a few minutes but then it cuts out. I don't think the motor is bad. The power nozzle had not been turned on for quite some time and may not be used to running? I am wondering if something needs lubing but have no idea where to apply or what to apply from a lube perspective. The motor does not get too hot or anything like that. The motor sounds fine when it is running. I was thinking about taking the motor apart and cleaning any dust that might be hindering something. The brush roll is clear of any hair so that is not the issue.
Does anyone have any recomondations for trouble shooting?
Thanks much!