Canadian Kirby 509

[oatmealman]

I recently picked up a Canadian 509. It appears the front bearing is riveted into the bearing plate. Is the correct bearing number 1160? Did US models also use a riveted plate? Thanks

 

[kirbyclassiciii]

I recently picked up a Canadian 509. It appears the front bearing is riveted into the bearing plate. Is the correct bearing number 1160? Did US models also use a riveted plate? Thanks


View attachment 170103View attachment 170104

Yes, they did. The specific front and rear bearings continued to be used even after Kirby changed the motor design with the 1956 model 516, up through to the 1970-73 Classic 1-CR.

~Ben

 

[oatmealman]

Thanks. When did they stop using the bearing plate that's riveted together?

 

[kirbyclassiciii]

Thanks. When did they stop using the bearing plate that's riveted together?

Midway through production of the 1951 model 511 (S/N 383346 and earlier had the riveted plate; S/N 383347 and up had the revised plate with screws).

~Ben

 

[cheesewonton]

Midway through production of the 1951 model 511 (S/N 383346 and earlier had the riveted plate; S/N 383347 and up had the revised screw-on plate).

~Ben

Where else but Vacuumland could you find that kind of information !