Bearing Press?

[royalfan103]

I found this on Amazon! I think we’re gonna be out of the eras where we need to use a hammer on shaft to press on bearings.

https://a.co/d/duCWFZh

 

[herbicide]

I found this on Amazon! I think we’re gonna be out of the eras where we need to use a hammer on shaft to press on bearings.

https://a.co/d/duCWFZh

I've got one just like that. Doesn't get used much, but it is certainly worth it when it is used!

 

[centralsweeper63]

How would it be used.

 

[royalfan103]

How would it be used.

 

[blackheart]

I just bought one. I change bearings all the time. Thanks for the heads up!

 

[centralsweeper63]

Thank you for that link.

 

[royalfan103]

Thank you for that link.

You’re welcome.

 

[blackheart]

Well...It WAS here....about 2 hours ago and someone stole it....lovely.

 

[cheesewonton]

Well...It WAS here....about 2 hours ago and someone stole it....lovely.

Porch pirate ?

 

[centralsweeper63]

That is a shame. I hope you can get it back.

 

[blackheart]

Good news and bad news. The good news the "theft" was accidental, an older person's son had told her a package had arrived, there were two of them in the picture and she picked this one up without checking the address. When she realized the mistake she brought it back and apologized. Not a big deal mistakes do happen.
Now for the bad news....This is too small for me to get much use out of. I was going to use it to press some new bearings onto this Miele's armature but even though it's a single stage motor this armature is just too tall to fit into the arm space. Unfortunate, but perhaps i'll just need to seek out a taller model in the future.

 

[centralsweeper63]

Hopefully one is available.

 

[herbicide]

Well shucks... This is similar to the one I have, around 6" of clearance:

https://www.amazon.com/dp/B0CGJ4QT17