thevacuumman
Well-known member
First, the Hoover Special 825 has had its motor overhauled
Some Updates
- Thread starter thevacuumman
- Start date
Help Support VacuumLand:
thevacuumman
Well-known member
Next...
The TriStar has been rebuilt and I had put a new badge on it so now it is the "Compact CXL"
The TriStar has been rebuilt and I had put a new badge on it so now it is the "Compact CXL"
thevacuumman
Well-known member
And last...
The Hoover Encore has been gone through and cleaned up
The Hoover Encore has been gone through and cleaned up
hoovercelebrity
New member
Nice Hoover Encore.. I think that was the last of the last of the Convertibles. I have one of those in storage. 
thevacuumman
Well-known member
Hoover Encore
I really like it, it was well worth the $2 I paid for it.
I really like it, it was well worth the $2 I paid for it.
markanthony5
Well-known member
Help i need some advice badly on an 825
Hello there,
I am new to this site thought i would have a look round.
I have a Hoover 825,the problem with mine is i am convinced that it needs new bearings top and bottom they sound rough.
A friend suggested i oil it,correct me if i am wrong but they are not supposed to be greased.
I am thinking my bearings are worn out and my 825 has had a hard hard life,as its covered in knocks and scratches and dents and dings.I am at the moment sanding as much of them out as possible before polishing.
I went to my local Hoover repair shop and another their too scared to touch it, and don't know what bearings i should have and what size.Would you know the answer to this.
I also need to make a new rubber surround for the headlight area,but not sure how too.
I live in the united kingdom by the ways
Hello there,
I am new to this site thought i would have a look round.
I have a Hoover 825,the problem with mine is i am convinced that it needs new bearings top and bottom they sound rough.
A friend suggested i oil it,correct me if i am wrong but they are not supposed to be greased.
I am thinking my bearings are worn out and my 825 has had a hard hard life,as its covered in knocks and scratches and dents and dings.I am at the moment sanding as much of them out as possible before polishing.
I went to my local Hoover repair shop and another their too scared to touch it, and don't know what bearings i should have and what size.Would you know the answer to this.
I also need to make a new rubber surround for the headlight area,but not sure how too.
I live in the united kingdom by the ways
