Do these sound right?

[vacuumlover]

The U2716 doesn't sound quite right to me at all. I'll try and put it as short as possible ~

So I got it a brand new motor a while back but the commy was all pitted, then I got some wet and dry sand paper (as I don't have a commy stick) to remove as much of the pits as possible. Iv'e let it run for a while (about 5 mins at a time over a period of days)

It just sounds a bit rough to me. Just doesn't sound right.

Now the U2464 ~

I know the brushroll bearings need replacing as they sound sh*t. Pardon my language

I know it's only 700 - 800 watts but it sounds a little "slow" to me. Maybe it's because I'm used to my 1000. And no,I didn't clean the commy this time. I did grease all the bearings.

So any help is greatly apprenticed!

 

[sebo_fan]

As far as I can remember the brush rolls sped at a different speed with the TP2 models that I owned. Thus the lower power spun at a different speed to the two other levels.

 

[vacuumlover]

@sebo_fan

It does. I only put the camera down like that because I couldn't be bothered to hold it. Silly excuse I know.

 

[sebo_fan]

Both sound okay to me, but then I haven't owned the Hoover U2716.

The brush roll on your U2476 looks like it is either bent or the bearings ends at each end might be out a bit - if you look at the first vacuum, you'll see slight movement of the bumper/hood moving up and down a bit.

 

[vacuumlover]

One of the end caps is rusted pretty bad,so that could have something to do with it. I'll most likely nick it off the 1000 as I don't use that,that much.

Thank you for your help

~ Looking closely at the video,the right side seems to be bouncing up more. That's the end with the buggered end cap.