Recent content by thevacuumman

VacuumLand – Vintage & Modern Vacuum Enthusiasts

Help Support VacuumLand:

  1. thevacuumman

    I bought a "New" Maytag Set

    I picked this matching washer and dryer set up at a garage sale for $300. Best I can figure on the serial number for the dryer it was made in April 2004 going off of the chart I found online. Both run like a champ and have done well for their age. I retired my Maytag DG308 and Estate ETW4400WQ0...
  2. thevacuumman

    I installed my "new" dishwasher!

    My GE dishwasher bit the dust. I went to start it and there was no signs of life from the controls. It had been getting finicky lately and I knew it was on the horizon. I installed the Kitchenaid KUDI220T4 I got from my old boss a couple years ago. It is in good shape and it was just pulled out...
  3. thevacuumman

    Panasonic straight suction canister

    I have had the motor cover off of mine. Its a bit tricky to get the "pedal" off, but I did so, and there's a few screws underneath and the motor cover should come off. Sorry for the delay and if needed, I can open my machine up and provide some pictures.
  4. thevacuumman

    Might get this for Christmas

    I'd say go for it. They aren't bad at all. My neighbor has one as its a lot lighter than the Kenmore Progressive Direct Drive she had. Her daughter bought her one of those and I agreed to do a monthly service on it for her. It works well for her needs and she can use it a lot easier than her...
  5. thevacuumman

    Panasonic straight suction canister

    So I have one of these machines! Mine doesn't have the original wands or floor nozzle though. Mine does have a slightly different label, but is the same model. I can get some better pictures later, but its nice to see another one of these machines.
  6. thevacuumman

    WHERE IS EVERYBODY???

    I'm a daily reader, but I don't post as much as I'd like to. My career and family keep me pretty busy but I do check here daily.
  7. thevacuumman

    The Riccar Vibrance has returned

    I'm excited to see these! I wouldn't mind having one myself, but not a priority as I have a few Riccar machines. I have a Vibrance Classic I purchased new in 2013, a HP-3000, and a 8950.
  8. thevacuumman

    (2000) Eureka Millennium 2000 bravo 2 model 7676.

    What is the brushroll width? I have a Bravo II baseplate and brushroll but I need to measure the size. If they'll work for you you can have them for the cost of shipping.
  9. thevacuumman

    Forgotten Eureka Products

    The Eureka Aero comes to mind to me.
  10. thevacuumman

    Aerus/Electrolux Motor Ring Needed

    Let me look in my stash. I might have one.
  11. thevacuumman

    are these worth getting? hoover/riccar

    I have a newer iteration of the Riccar. I have a 2013 Vibrance Classic and it is a rock solid machine. I bought it new with the deluxe attachment kit for roughly $300 and it has been a great machine. My wife loves using vs her Hoover Windtunnel XL she bought in December of 2021.
  12. thevacuumman

    Hoover Dual Voltage Convertible

    I found this at the Habitat Restore in Amarillo a little while back. This machine purrs like a kitten. It's interesting to find one of these 120v/60Hz 240v/50Hz machines in the wild to me. It's joined my fleet of Hoover Vacuums and it's kinda cool to me.
  13. thevacuumman

    Rare color variants of particular vacuums

    To me it's this straight suction Kenmore in translucent red and grey. I wish I still had this machine.
  14. thevacuumman

    Hoover 6 Gallon Wet Dry Vac Tank Latches

    Would anyone have a couple of these laying around? I bought this machine a couple years back and I'm finally getting around to it on my back log of machines.
Back
Top