Latest activity

From the infamous Reddit page https://www.reddit.com/r/VacuumCleaners/s/atMa9T7wHK

I have this old Dirt Devil corded handheld in my closet. It's actually a pretty neat little machine. But the sound is so loud I'm...

Oh I see. My apologies. I am familiar with those lines. I personally haven't experienced any cracks on my V15 but I don't doubt...

How is all this bearing out for you:

Oh.. By 'molding flow lines' I meant the plastic parts "molding" as they were built; where the hot molten plastic becomes cold, then...

Well shucks... This is similar to the one I have, around 6" of clearance: https://www.amazon.com/dp/B0CGJ4QT17

Mold is a good point. Especially with them just sitting there. I'd definitely be wearing n95 masks if I were to take on the challenge...

This is such an irrelevant thing to say because, if you'd looked at the evidence provided for you, you'd see there was no evidence any...

I don't mind one mistake. My reputation is gone with you, though I know that I don't mind.

From the infamous Reddit page https://www.reddit.com/r/VacuumCleaners/s/atMa9T7wHK

I would add cracked housing (molding flow line issues). I know this will blow a few minds around here but I still like my V7 after...

Assuming the motor itself isn't shot on those you could probably fix them with an air compressor on the cyclone assembly\filters and a...

Assuming the motor itself isn't shot on those you could probably fix them with an air compressor on the cyclone assembly\filters and a...

I like the design of the British Hotpoint uprights of the 1980’s. Here’s Beko1987 putting together a Hotpoint Junior upright on YouTube...

Hopefully one is available.