WANTED: Parts and Repair for Early, 1960?, Electrolux Model G Canister (1960-1966)

[darlasrock]

I am looking for the following parts, used is fine as long as it is in good condition because I plan on using it as well as keep it as a family heirloom collectible:

1) Motor bearings or the whole motor, original.

2) The rear end or recoil, cord and circuit board.

3) Front end.

4) Original hose preferably with pigtail.

5) 2 metal extension tubes

6) Motor 'Rug Beater'

7) Duster (with wings)

8) three original blue wheels

9) Manual

10) crevice tool and other accesories, except floor duster.

I am looking for someone who does restoration repairs.

Please send an email to [email protected]

 

[bagintheback]

If I am correct, I have the duster. I can post a picture as soon as I get a battery for my camera.

 

[bagintheback]

Oh yes and I have the 2 metal extension tubes too.

 

[compactelectra]

Sounds Like

You should just buy a nice one off of Ebay and raid it for the parts. That would work if you want to restore a machine for sentimental reasons. I know a guy near Milwaukee that owns a vac shop that could do the repairs. Or you could go to an Aerus dealer, the sucessor to Electrolux and have them do it.

 

[kirbykid63]

I have a whole body

I have a very nice blue model G body in my Ebay store $20.00,I get lots of model G's that I rebuild the motors on and sell the parts.

Richard
new2youvacuum on Ebay

 

[kirbykid63]

Whoops that's new2youvacuums on Ebay.check out my store I have some nice parts and always getting stuff in.

Richard Groski
new2youvacuums