repairman
Well-known member
Would a Hoover Convertible brushcore fit on the end of a Dial A Matic Pulley? If this is the case, I will order the pulley and fit a used brushroll.
Question about Hoover Brushroll
- Thread starter repairman
- Start date
Help Support VacuumLand:
repairman
Well-known member
Keep in mind that this is for a self propelled machine.
No, they wont fit. I'll look in the attic, I think I threw a few up there.
repairman
Well-known member
Here's my situation.
I work at a vac shop and have had a few people call about a Hoover Concept or Dial-A-Matic Brushroll (Yes, I know the endcaps are different). We have some 160538 pulleys which were for the Powerdrive Dial-A-Matics only. I want to put the pulley on the end of the Convertible brushroll and then just use the Concept's rod with endcaps and bearings. I only ask because I saw this picture (Credits to GJ3476).
I work at a vac shop and have had a few people call about a Hoover Concept or Dial-A-Matic Brushroll (Yes, I know the endcaps are different). We have some 160538 pulleys which were for the Powerdrive Dial-A-Matics only. I want to put the pulley on the end of the Convertible brushroll and then just use the Concept's rod with endcaps and bearings. I only ask because I saw this picture (Credits to GJ3476).
I know I tried it, but perhaps I'm confusing it on a non self propelled machine. I've spent the last few nights out plowing snow, and the days at work, so my mind is a jumble. I'll give it a try a d tell you.
repairman
Well-known member
Yo
Could you post the difference in length between the Powerdrive and regular DAM brushrolls.
Could you post the difference in length between the Powerdrive and regular DAM brushrolls.
