Huskyvacs,
Thanks for the insight. I tried removing the cam, and still had no luck. Even without the cam, i had to jam the handle forward. The pivot will not easily glide back and forth over the plate it sits over. Grease didn’t help either. Tried greasing the yoke and the joints, nothing. This may sound silly, but I think the yoke is bent where the pin from the pivot rests. I doubt that’s the case, but I do have a photo so you can see what I mean. Pushing the yoke back and forth with the pivot removed and the Kirby on showed tech drive was working as it should.
[ATTACH=full]132701[/ATTACH]
