Reply to thread

VacuumLand – Vintage & Modern Vacuum Enthusiasts

Help Support VacuumLand:

I believe this is what you're looking for.  You have, no doubt discovered that it is rather difficult to install.  The two ends have to be "convinced" to meet each other head-on.  This requires the use of at least two vise-grip type pliers to hold the wire in the groove of the bellows (at the opposite side from the open end and just below or above the open end) and a screw driver to "pop" the ends into position. Take care not to chew up the paint finish with the pliers.


http://www.avaccorp.com/-strse-65228/Hoover-60-dsh-62-BELLOWS-RET/Detail.bok


   

Hoover 60-62 BELLOWS RET RING



SKU:

    76448HUG

MPN:

    45376

OEM:

    HOOVER by TTI


Hoover 60-62 BELLOWS RET RING

RETAIL PRICE: $4.95


YOUR COST:

$2.25 @ 1 minimun quantity purchase

$1.95 @ 10 minimun quantity purchase


Hope that helps.


Marty


Back
Top