Reply to thread

VacuumLand – Vintage & Modern Vacuum Enthusiasts

Help Support VacuumLand:

Derek,


Try flipping it over and watch while it runs. See if you can hear any rubbing or see anything that doesn't look right. Let it run a couple minutes, the belt may come off, maybe not. If you see it coming off, hopefully you can pin point the cause. I wouldn't use a belt that is too tight or small for long as it can be rough on the bearings. I'd get the proper belt using the numbers listed a few replies back. Once you know you have the right belt on you can rule that out as cause for slipping off.Good luck and cheers! Billy


Back
Top