blackheart
Well-known member
Just in case we have anyone out there familiar with commercial extractors I thought i'd put this out there.
I picked up this mytee a while back for $50 with the intention of restoring it for personal use.
It's specs were pretty weak 100 PSI 100 CFM 130"
I bought this pumptec pump (new condition) from ebay which is for a Windsor compass 2 and rated for 700 psi which would be excessive for the application so I figured a new regulator or unloader would be in order. It was like half the cost of the 300 PSI pumptec 112 i was looking at, couldn't pass up that deal!
For those who are familiar with the pump side of things Would it be better to use a static pressure regulator or perhaps to get a variable pressure unloader? I'm thinking it'd be best to bring it down to like 400 psi
The vacuum motor i'll be looking to upgrade to a dual stage 6.6 motor with specs around 130 for both lift and airflow.
I picked up this mytee a while back for $50 with the intention of restoring it for personal use.
It's specs were pretty weak 100 PSI 100 CFM 130"
I bought this pumptec pump (new condition) from ebay which is for a Windsor compass 2 and rated for 700 psi which would be excessive for the application so I figured a new regulator or unloader would be in order. It was like half the cost of the 300 PSI pumptec 112 i was looking at, couldn't pass up that deal!
For those who are familiar with the pump side of things Would it be better to use a static pressure regulator or perhaps to get a variable pressure unloader? I'm thinking it'd be best to bring it down to like 400 psi
The vacuum motor i'll be looking to upgrade to a dual stage 6.6 motor with specs around 130 for both lift and airflow.
