Search results

I have taken this unit apart to access and clean the switch. I am stumped for removing upper section from base. All screws are Torx head. Need to remove inspect and check Electrical switch. Customer said it would not run but it does run with no problems. I'll change filters when reassembling...

This self propelled vac used one of three agitator brushes: 48414004, 48414013 or 48416009. I need a new one to replace the worn bristled original. http://shermanstops.com

I thought I posted this query earlier today but it doesn't show up...sorry if this is a duplicate post. The G4 Belt Lifter needs to be wire brushed to remove rust and corrosion, sprayed with lacquer, silicone lube and reassembled. It is fastened to the square knob with a coarse screw. I have...

Photo shows the right side of the chassis where three large connectors are fine. But there is a smaller connector with a female tab and I cannot locate it's match. The schematic from www.vacpartswarehouse.com is difficult to discern on this item. Please guide me. Thanks.[this post was last...

I have posted recently about my project to repair a Fantom Twister 700LX. I have solved the intermittent wiring problem and started reassembly. The customer took it apart to try to fix it and failed. After I brought it home I found these two parts (pictured in three positions) inside it. Any...

The Hoover website lists this part number 38634078 as not available. I need a pair. They measure 16.5" long x 1-1/2" ID on top end and 1-1/4" OD on bottom end. My feedback on eBay is 100% positive.

I am about halfway through disassembly needing to access the motor compartment where there is a clump of lint. I cannot find a way to remove the back cover from the frame structure. That three piece assembly is like a sandwich...the bag cover is the front, frame in the middle and back cover. I...

Three weeks ago this FM780 vac was brought to me for repair. It operates effectively but cuts out when handle is at 12 o'clock position. I have cleaned most of the parts and located the 2000 annual corporate report of Fantom Tech. I have gathered some feedback from forum members who had...