Search results

It could definitely use a rebristling and should have wire rug guards to keep the rug from being sucked up into the vacuum.

I found this one at Goodwill for $5, I picked it up for a dealer I know.

If you take the control valve out and unscrew the knob I'm guessing that the plastic around the O ring has broken off and the valve is leaking. You can still get the new knob/control assembly from your local Aerus dealer.

Ben I have a G4 and yes it was the last model to use Phillips screws. It also shares the brush roll with the G3 so the wear indicator light is on the left when you stand behind it.

G4 used Phillips head screws.

part # 179489S Wedge - Slide Adjustment G3 thru Diamond Edition

The lavender color tape for the bumper Just so you know I was helping Scott at Tinley Park Kirby and he has a whole roll of the tape for the G4 bumper. It still has 5 stripes left on the roll.

Found this at Goodwill today for $5

Very Nice

Yes

Just thought you might like to know there was a Kirby 520 at the Goodwill on 159th and Harlem.

I got stimulated and my Hoover 102 got converted. I finally got a converter for my Hoover 102 and 105.

Looking at the manual it has a 2681 number on it so it goes with a Hoover 105

Do NOT follow reply #2 directions. You don't need to take out every screw, rivet, switch, handle, etc. First off before you pull the motor apart take out the carbon brushes. Then the bearing bridge at the fan end should just unscrew. I think the bearing will just slide off the end of the...

Looking at the name plate on the front I'm guessing Apex model 57 or 58.

The manual looks to be a 102 or 105 manual. Your 541 is an early 541 since the brushroll has six sets of bristles on each side of the pulley. The later 541s had 5 sets of bristles on one side of the pulley and 7 sets of bristles on the other side of the pulley. The 6/6 is on the right and the...

61 used two different agitators 45474 or 46849 Brush strips depending on which agitator you have Nylon 32667 & 32668 Nylon 47159 & 47160 Horsehair 82667 & 82668 Horsehair 86679 & 86680

It goes back to that saying Whatever the market will bear. I personally wouldn't pay that since I bought my Vac-u-ette Model C for under $100.

Here's a picture of the insides of an Electrolux XI

In picture 5 see that cap that is laying on the workbench. The center of that is where the front bearing for the armature is and then in the rear of the motor housing is a hole in the center where the rear bearing for the armature goes. The center has a cap that unscrews (see the two little...