Recent content by mmcphee

Given the fact that Proteam and Ridgid are both owned by Emerson Tool Company, it is no surprise that Ridgid would eventually have a backpack vacuum. To me, it looks like it is based off of the Proteam Super Coach Pro 6 backpack vacuum with a different tool set and a shorter cord at only 20...

Floor Tool My mother has had 3 of these vacuums. Check to make sure the floor tool is fully seated into the top of the power nozzle. Yes, the floor tools lifts out of the top of the power nozzle and if it's not fully inserted, the electrical connections won't connect.

Diamond Edition I have a Kirby Ultimate G Diamond Edition and it has the same air intake guard as the G5 except in a different color. Is the air intake guard that was supplied with my Kirby sufficient or does it require modification?

I seem to have no luck on eBay when it comes to finding the Here's Proof book for an Ultimate G Diamond Edition. Does anyone have suggestions as to what the magical phrase is to find them on eBay? I have searched everything I can possibly think of and I am not finding anything.

Lesinutah Do you have the chart? If so, could you upload a picture of the front and back of it?

Lesinutah I've found that Kirby hasn't been too terribly good at getting back to me and I've searched the image. I'm trying to recreate the document in Microsoft Publisher and the images online are far too blurry to read the small text.

Does anyone happen to have the Stain Removal Chart that came in the Kirby Carpet First Aid Kit box that they would be willing to post high-quality photos of? In the picture below, it is the double-sided chart on the lid of the box that I am talking about.

Does anyone have a Kirby Sentria with every single optional accessory offered by Kirby and would they be willing to share photos?

I have an absolutely immaculate Kirby Ultimate G Diamond Edition and the transmission is a little bit noisy when it is off and in neutral. I am thinking of just replacing the transmission because I know where I can get them brand new and cheap. My only question is that if I buy a new...

Does anyone know the part numbers for the small "midget" crevice tool and the plastic attachment caddy for the LUX 6000? I can't find a good picture for the crevice tool.

Does anyone happen to know the part number for the cartridge filter that goes in a early 2000's Aerus/Electrolux CentraLux power unit?

Does anyone happen to have a high-quality scan of the page in the owner's manual of a Electrolux Model R or Model G where it discusses the Gleaner Bar on the Combination Floor Tool?

Owen Since I actually have the Lexan inlet hooked up to my Model 26, I will certainly forgive the omission! I did get some screws for my inlet and they do go in at an angle but it should work. I had my local vacuum repair shop solder the wire on (didn't want to burn my finger again) so it...

Vackid Thank you for your comments on the inlet. Before I can even get to installing it, I have to solder a wire onto it for the low voltage. When I received the inlet, It had no wires on it at all. I managed to get the wire for the pin jack from an automotive lightbulb holder that I bought at...

Hello everyone, I have been doing some planning to when the circuit board in my Model 26 finally bites the dust. The vacuum runs fine with no issues so I just was wondering how the rest of you managed to put in the newer circuit board from VacuFlo into this unit specifically with the low...