Recent content by erikd

Okay, so I took the machine apart this weekend. It really didn't look too bad. I'd say the brushes were at about 70% and the bearing didn't seem to be worn out. I did replace these parts anyway and cleaned everything including the brush holders. The armature was smooth. I could not detect...

Thanks so much everyone! Just the kind of advice I was looking for! You guys rock! Those instructions are sweet! I'll be operating this weekend. I'll let you all know what I find. Thanks again, Erik

I'm an engineer so don't have any issues at all with taking the machine apart. I was just looking for some insight as to where I should focus attention or common problems that I should address.  Maybe part numbers for the bearings. I'm assuming the motor will need 2 bearings. Does the fan...

Hello, I'm new to this forum and could use a little advice. I have a Factory Refurbished Model G (Hammertone Blue) that was purchased "re-newed" back in the early 70's and then handed down to me when I left home for college in the 90's. It's been a faithful companion ever since. Lately I've...