I think you should get that checked out
As far as I know, with any electrical devices cord getting warm- or warm hot, you should take it in for matinence. Better safe than sorry for a potential house fire
I'm planning to start on the restoration on this Kirby in a while as I'm finished with my Sentria.
I am going do replace the Powerswitch in this machine.
For fun- I'm not going to tell you which Kirby it is but here are some clues on the model it is.
1. This model is the only Kirby to have 4...
This is a thread that I started to talk about Kirby’s mainly, first question where does the air from exhaust vent take air from? I see where it comes out but where does the air go in to cool the motor? This question applies from the Generation 3 All up to the new Avalir.
I know this thread Is preety much dead but
If I was to buy the power switch online would someone put it in for me?
The DIY Instructions seem a little bit hard for me, mainly moving the Techdrive pieces around.
-Bryce
Does it look like im done?
Just used Mother's Yesterday and I got a cross between a mirror and a dull finish.
Do I need to completely restart or can I Start back at 1500 with Mothers?
Also how do I remove the liver spots on the sides?
Thank you for all the support you’ve given me on this site!
Sorry, I accidentally Posted on Wrong thread
I intended to click my Link and I accidentally clicked yours instead, can a moderator delete my above post?
90 percent done with the handle
I Made some REAL progress on the handle.If you look close enough, you can see me in the reflection.
Question, Should I use Mothers or Blue magic?
I Think I did a really good job
When I First got it from Value Village it looked like this. Some part of me wished I got the Heritage 2 Legend, but it had no powercord so I could not test it.