Recent content by aaron158

brave little toaster was my fav movie as a kid and what made me want a Kirby. wish Disney would release remastered on bluray.

i dont have a caliper

yes i am aware of that i just would like to know the size of the bearing that the brush rollers use.

does anyone happen to know the type number used in the brushroll bearings on the Kirby heritage out of 3 rollers i own only 1 bearing had any writing on it and it was super hard to read but i though it said 687-2rs ordered one of those though and the outer diameter is smaller.

aren't those screws put in there in a way as to make it so u aren't suppose to remove them like they hammered out end of the screw to lock it in the hole so u can't remove it. i removed one once on a heritage 2 fan can and it shredded the hole luckily it was a parts machine so wasn't a huge deal...

is Kirby getting rid of all there service centres or something. use to be one here in London ON but when i called the a few months ago number was disconnected and its no longer listed on the Kirby list. seems like there's only 1 in Canada that's within 500 miles in Ajax ON seems like its just a...

@keither surprised paypal would let u dispute that in the past were I've ran into things like that were sellers ripped me off on shipping paypal when id try open a dispute it would just auto close the dispute on me saying we don't cover that. ebay also even though they say its breaking the rules...

https://forums.redflagdeals.com/netparcel-x-paypal-lava-hot-ups-purolator-dhl-shipping-rates-45-60-off-no-minimum-required-2296241/ ask them to try out this netpacel thing not sure how good the rates are for within the us. but here in Canada there rates were discounted quite a bit over our post...

They sell a lot of parts for electronic repairs. problem is a lot of what they list isn't in stock and when u order it they contact the manufacture and they don't have it. so unless the item is in stock or something that is current product from the past couple years its probably just a waste of...

id say just order the part that KirbyClassic linked but rather then waste $50 buying the tool for winding it that u will only use once take the part and your machine into a small local vac shop they will probably have the tool on hand and will probably put the new one on for you for not a lot of...

u need a 9mm wrench for any g series. the locking tool part T130 is only for pre g series.

the white wire for the light goes into the hole on the very bottom of the power switch he whole next to that is the black wire that goes inside to the motor and at top of the switch u plug in the wire that goes to the carbon brush on the top of the motor.

u need what is called a power inverter...

this would be more for cutting ur hair. i mean u could do ur beard with it but it but it would only trim it down so short not like all the way off. i need to get one of those long bottle brushes to clean the hose out. it smelled musty i've filled it out super hot water and soap several times...

quick up date. wahl c/s finally got back to me and said that i needed part# 1006 they offered to send me some. got them today and they are pretty much the same as the factory blades other them having wahl marked on them witch the original blades did not.